Incredible Adding Cabinets Above Upper Cabinets References. Add a 2×2 board to the top of your cabinets with 2″ brad nails and a brad nailer. The next step is to reface the entire cabinet.
Adding to Upper Kitchen Craftsman Geneva, Illinois from www.kitchencraftsman.net
W hile we were waiting on my new bank of cabinets to arrive, the ones that go to the right of my dishwasher, there hasn’t been much progress on the kitchen since the day everything was torn apart. I figured 12″ cabinets would be perfect because we could fill in the remaining 6″ of space with molding. Use a cordless screwdriver to secure the cabinets together.
Add A 2×2 Board To The Top Of Your Cabinets With 2″ Brad Nails And A Brad Nailer.
Typically, cabinets of this depth are used as extra storage above a refrigerator, but because they were so deep, they were perfect for this application, too! A lot of kitchens have a space between the ceiling and the tops of the upper wall cabinets. Slide a 2 1⁄2 in (6.4 cm) screw into each hole.
Painted Pitchers, Handmade Ceramics, Or Decorative Plates Are Always A Great Start.
Give the new upper cabinet a custom look we had about two feet of space above our cabinets and i made these 16 inches tall. Once the structure is extended, we reface the cabinets in order to hide any seams and structural changes so they are essentially brand new, taller cabinets with new doors. The set of cabinets that were originally over my fridge (circled below) measured 12 inches in height.
On The Front And Each Side.
W hile we were waiting on my new bank of cabinets to arrive, the ones that go to the right of my dishwasher, there hasn’t been much progress on the kitchen since the day everything was torn apart. Option 1 // bring cabinets (or a soffit) to the ceiling. Measure from the back wall to the front edge of your face frame.
Add 2×2 Boards To Top Of Cabinets And Ceiling.
Here are a few ideas to make that space actually work for you — and me! At this point, filling them in with a small cabinet will serve me 2 purposes. We held a scrap piece of 1/4″ plywood in front of the 2×2 to line it up correctly when we clamped the 2×2 down.
The Lone Cabinet To The Right Of The Sink Is About 1/16 Or Close To 1/8Th Short Of 12 All The Other Cabinets Are Same Height But A But Shorter In Space Above.
I was adding a header above and wanted to leave enough space for that and decorative trim. We had 18 inches of space between the top of the cabinets and the ceiling. The next step is to reface the entire cabinet.
